12/15/2023 0 Comments Remove door window trim evom![]() (Put your door on something non-abrasive so you don’t have big gouges in the paint when you pick them back up). We used a bunch of spare plastic clips to attach the cardboard to the door. After cutting out an initial piece, we placed it against the door and started to poke out holes where the plastic clips used to be. The HUD board up procedure uses plywood covers for window and door openings that are held in place using carriage bolts and 2 x 4 braces on the interior. Once its gone there are just 2 push clips per side to remove that trim. ![]() on the bent over tabs, take a 'church key' and hook the tab. not too many of them i think, the legs and screws. We used a roll of Ram Board, a contractor type of cardboard used for protecting floors, and highly recommend you do the same. To remove the plastic cover that goes on the inside edge if the window frame the trim panel has to be removed. How do you get it off with ruining it nate, if its the trim on the doors/windows and not the drip rail then there are some tabs that are bent over and some legs off the trim that go into the fuzzy and are held by a couple of screws. To get these door cards fitting perfectly (and ensure we only had to cut plastic once per door), we made up a template that was sturdy enough to stand up to the tough demands of garage DIY-ing. That’s not how we do things at Brain Power Motorsports! You want all your shiny new door cards looking the same when you’re done, so the worst thing you could do is try to save a bit of time up front and try to cut plastic mounted to your actual door frame. The best things in life are usually worth doing more than once, and the same thing goes for your car’s new door diet. Ram board cut to make our custom door card template. If you can find adhesive promoter,thats great, use on car surface.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |